Updated Cisco 300-370 Exam Questions – [Jan-2018 Dumps]

Cisco Certified Network Professional Wireless 300-370 certification exam success is guaranteed in the first attempt without any failure is possible now with the best Cisco Troubleshooting Cisco Wireless Enterprise Networks 300-370 exam dumps preparation material is designed by the professionals according to the needs of candidates who want to prepare for the Cisco 300-370 exam in a short time perfectly. The Cisco 300-370 exam dumps preparation material consists of the practice test software as well as PDF Q&A booklet that contain the most recent questions of Cisco 300-370 exam.

300-370 exam questions, 300-370 PDF dumps; 300-370 exam dumps:: https://www.dumpsschool.com/300-370-exam-dumps.html (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-370 Dumps Exam Questions and Answers:

Version 8.0
Question: 21

Access points ate deployed in an office building and users report that the real-time
communications quality of experience is poor when users walk between the elevators The
elevators are a heavy metallic obstacle, and AP 3 was installed to cover the elevator area,
which AP t and AP 2 signal does not reach Communications are captured for a user
walking from point A to point C. and it is observed that the user iPhone device suddenly
scans all bands and then roams from AP I to AP 3 somewhere between points B and C
WLAN is set to 5 GHz only. Open, default rate configuration. Which action improves the
real-time application quality of experience in this area?
Refer to the exhibit.

A. Enable 802 11v on the WLAN
B. Enable 802 11r on the WLAN
C. Enable 802 11k on the WLAN
D. Move AP 2 to point B

Answer : B

Question: 22

An engineer is troubleshooting non-802 11 interference and observes this output. Which
type of interference signatures can the engineer identify?
Refer to the exhibit.

A. microwave
B. DECT phone
C. Bluetooth
D. jammer

Answer : A

Question: 23

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two)

A. show sysinfo
B. show udi
C. show inventory
D. show boot
E. show tech-support

Answer: AB

Question: 24

While reviewing Clean Air data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting?

A. informational
B. major
C. minor
D. warning
E. critical

Answer: D

Question: 25

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

A. rogue AP containment
B. RF detection
C. switch port tracing
D. wire detection
E. Cisco Prime Infrastructure location services

Answer: A

Question: 26

Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages?

A. debug pm pki enable
B. debug cert events enable
C. debug capwap events enable
D. debug capwap packet enable
E. debug capwap errors enable

Answer: E

New Updated 300-370 Exam Questions 300-370 PDF dumps 300-370 practice exam dumps: https://www.dumpsschool.com/300-370-exam-dumps.html