Cisco CCNA Routing & Switching 200-125 CCNA Exam Preparation Material For Best Result

Cisco 200-125 practice exam software has different modes of learning to practice yourself according to your own convenience. Cisco Certified Network Associate exam is also ready through PDF Questions format to and experienced you with the real Cisco Certified Network Associate exam format. It will help you to prepare for Assistant Support Engineer, Network Administrator and Routing and Switching Solutions Specialist.

Try it Latest DumpsSchool 200-125 Exam dumps. Buy Full File here: https://www.dumpsschool.com/200-125-exam-dumps.html (297 As Dumps)

Download the DumpsSchool 200-125 braindumps from Google Drive: https://drive.google.com/file/d/1U-OGlj2xDMAR6MBZ1bMNACdp02vK4uut/view (FREE VERSION!!!)

Question No. 1

Which two approaches are common when troubleshooting network issues? (Choose two)

Answer: A, B

Question No. 2

Scenario:

You are a junior network engineer for a financial company, and the main office network is experiencing network issues. Troubleshoot the network issues.

Router R1 connects the main office to the internet, and routers R2 and R3 are internal routers.

NAT is enabled on router R1.

The routing protocol that is enabled between routers R1, R2 and R3 is RIPv2.

R1 sends the default route into RIPv2 for the internal routers to forward internet traffic to R1.

You have console access on R1, R2 and R3 devices. Use only show commands to troubleshoot the issues.

Examine the DHCP configuration between R2 and R3; R2 is configured as the DHCP server and R3 as the client. What is the reason R3 is not receiving the IP address via DHCP?

Answer: B

Question No. 3

SIMULATION

Central Florida Widgets recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring R1PV2 routing using the router command line interface (CLI) on the RC.

Configure the router per the following requirements:

Name of the router is R2

Enable. secret password is cisco

The password to access user EXEC mode using the console is cisco2

The password to allow telnet access to the router is cisco3

IPV4 addresses must be configured as follows:

Ethernet network 209.165.201.0/27 – router has fourth assignable host address in subnet

Serial network is 192.0.2.176/28 – router has last assignable host address in the subnet.

Interfaces should be enabled.

Router protocol is RIPV2

Attention:

In practical examinations, please note the following, the actual information will prevail.

1. Name or the router is xxx

2. Enable. secret password is xxx

3. Password In access user EXEC mode using the console is xxx

4. The password to allow telnet access to the router is xxx

5. IP information

Answer: B

Question No. 4

which address prefix does OSPFv3 use when multiple IPv6 address are configured on a

single interface ?

Answer: A

Question No. 5

Which three encapsulation layers in the OSI model are combined into the TCP/IP application layer? (Choose three)

Answer: B, C, D

Question No. 6

Which three are valid modes for a switch port used as a VLAN trunk? (Choose three.)

Answer: B, C, D

Question No. 7

Which command should you enter to configure a single port to discard inferior BPDUs?

Answer: C

Leave a Reply

Your email address will not be published. Required fields are marked *