Cisco 200-601 Pracitce Exam Questions

Valid knowledge of Managing Industrial Networking for Manufacturing with Cisco Technologies topics is given in Cisco 200-601 exam dumps. Candidates who want to get job roles of Administrators, control system engineers and network engineers can get these DumpsSchool 200-601 exam dumps for stronger preparation.

Try it Latest DumpsSchool 200-601 Exam dumps. Buy Full File here: https://www.dumpsschool.com/200-601-exam-dumps.html (70 As Dumps)

Download the DumpsSchool 200-601 braindumps from Google Drive: https://drive.google.com/file/d/1oMQPi-opZIT9mjcu_fP4LS8vaQUjZnAu/view (FREE VERSION!!!)

Question No. 1

Refer to the exhibit.

Which two parameters can be used to diagnose an overloaded system? (Choose two)

Answer: B, E

Question No. 2

Which is an issue with running CIP Motion on a REP network and identifies an alternate resiliency protocol that works for CIP Motion?

Answer: B

Question No. 3

Refer to the exhibit.

The control system depicted in the exhibit uses VLAN 300 for all of its device ports and PVST is enabled on each switch to switch connection. L2SW4 was inserted between L2SW3 and L2SW5. Links FO2 and FO3 were added and FO1 was disconnected.

Prior to the installation of L2SW4, PanelView was able to communicate with PLC#1. After the change, PLC#1 and PanelView are still able to communicate but neither PLC#1 or PanelView are able to communicate with I/O #1.

L2SW4# show run interfaces FastEthernet 1/1

description I/O#1

switchport access vlan 300

switchport mode access

spanning-tree portfast

spanning-tree bpduguard enable

L2SW4# show interfaces trunk

Port Mode Encapsulation Status Native vlan Gi1/1 on 802.1q trunking 1 Gi1/2 on 802.1q trunking 1 Port Vlans allowed on trunk Gi1/1 1,3-9, 301-305,400 Gi1/2 1,3-9, 301-305,400 Port Vlans allowed and active in management domain Gi1/1 1,3-9, 301-305,400 Gi1/2 1,3-9, 301-305,400 Port Vlans in spanning tree forwarding state and not pruned Gi1/1 1,3-9, 301-305,400 Gi1/2

Based on the output from the switch, what is preventing I/O#1 from communicating with PLC#1 and PanelView?

Answer: C

Question No. 4

Which best describes the difference between 802.11n and 802.11ac?

Answer: C

200-601 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1oMQPi-opZIT9mjcu_fP4LS8vaQUjZnAu/view

Exam Vendor: Cisco dumps

Leave a Reply

Your email address will not be published. Required fields are marked *